Handset Volume Setting; Channel Setting; Channel Region; Memory - Furuno FM-8900S Operator's Manual

5. MENU OPERATION
5.2

Handset Volume Setting

You can adjust the volume of the loudspeaker for the handset.
1. Rotate the CHANNEL/ENTER knob to select [HS VOL] on the [MENU]
screen then push the knob.
2. Rotate the CHANNEL/ENTER knob to set the volume level then push
the knob.
5.3

Channel Setting

5.3.1

Channel region

You can change the channel region (see section 1.5).
1. Rotate the CHANNEL/ENTER knob to select
[CH MODE] on the [MENU] screen then push
the knob.
2. With [REGION] selected, push the
CHANNEL/ENTER knob.
3. Rotate the CHANNEL/ENTER knob to select the channel region then push the
knob.
5.3.2

Memory

You can easily call up the channel which you registered in the [MEMORY CONFIG]
menu (see section 5.4).
1. Rotate the CHANNEL/ENTER knob to select [CH MODE] on the [MENU] screen
then push the knob.
2. Rotate the CHANNEL/ENTER knob to select [MEMORY] then push the knob.
3. Rotate the CHANNEL/ENTER knob to select [ON] or [OFF] then push the knob.
When you select [ON],
lect the memory channel by rotating the CHANNEL/ENTER knob. The following
figure shows the example for CH 10.
Channel number
"5" means that you
turned 5 channels of
the selected channel
region to [ON] in the
[MEMORY CONFIG]
menu.
5-2
appears on the screen. On the RT screen, you can se-
Only permitted channel
modes are displayed,
which are set by the
installer of the equipment.
Channel status
for CH 10