Removing The Expansion Card Riser - Dell PowerEdge C4130 Owner's Manual

Catego Card Card type
ry priori
ty
PCIe NVMe half
SSD height, half
length
PCIe half
height, half
length

Removing the expansion card riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in before working inside your system.
3. Remove the PCIe shroud. See removing the PCIe shroud
4. If installed, disconnect the expansion card riser cables from the system board.
CAUTION: The expansion card riser cables must be removed before removing the expansion
card riser to prevent pin damage in the PCIe connectors on the system board.
Steps
Holding the touch points, lift the expansion card riser from the riser connector on the system board.
104
Configuration Configurations
s A and B C, F, and H
Slot Max Slot
priori allowe priorit
ty d y
1, 2 2 1, 2
1, 2 2 1, 2
Configurations D
and H
Max Slot Max
allowe priority allowed
d
2 1, 2 2
2 1, 2 2
Configurations
E and I
Slot Max
priori allowed
ty
1 1
1 1