Dell PowerEdge C4130 Owner's Manual page 98

Figure 28. Removing the system battery
1. system battery
3. To install a new system battery, hold the battery with the "+" facing up and slide it under the securing
tabs.
4. Press the battery into the connector until it snaps into place.
Figure 29. Installing the system battery
1. system battery
Next steps
1. Connect the GPU signal and power cables to the system board.
2. Follow the procedure listed in the After working inside your system section.
3. While booting, press F2 to enter System Setup and ensure the battery is operating properly.
4. Enter the correct time and date in the System Setup Time and Date fields.
5. Exit System Setup.
Related Links
Safety instructions
Before working inside your system
After working inside your system
System board connectors
Installing a GPU riser cable on the system board
98
2. system battery slot
2. system battery slot