Fan Motor; Gear Motor - Hoshizaki DIM-30DE-1 Service Manual

15. FAN MOTOR

1) Unplug the ice dispenser or disconnect the power source.
2) Remove the front panel (lower).
3) Remove the control box and air guide.
4) Disconnect the connector of the fan motor.
5) Remove the fan motor bracket and the fan motor.
6) Cut the leads of the fan motor allowing enough lead length to reconnect using closed
end connectors.
7) Install the new fan motor in the reverse order of the removal procedure.
8) Replace the panels in their correct positions.
9) Plug in the ice dispenser or connect the power source.

16. GEAR MOTOR

1) Press the push button to dispense all the ice in the storage bin.
2) Remove the front panels (upper) and (lower), and turn off the power switch.
3) Remove the four machine screws securing the motor bracket, and take off the gear
motor together with the auger.
4) Take off the motor cover, and remove the three machine screws securing the ice
guide.
5) Move the ice guide toward the auger, and remove the spring pin connecting the
auger and joint.
6) Remove the four machine screws securing the gear motor, and pull out the gear
motor.
7) To refit the gear motor, reverse the above procedure. Check for proper operation.
43