ENGLISH IMPORTANT SAFETY INFORMATION Throughout this manual, notices appear to bring your attention to situations which could result in death, serious injury, or damage to the unit. Indicates a hazardous situation which, if not avoided, could result in death or WARNING serious injury.
Page 4
* If the supply cord is damaged, it must be replaced by a replacement cord which is available from Hoshizaki Parts/Service Centres. * Do not touch the electrical parts or operate the switches with damp hands. * This appliance is not intended for use by persons (including children) with reduced physical,...
Do not remove any service panel secured with screws. Access to the service area is restricted to persons having knowledge and practical experience of the appliance, in particular as far as safety and hygiene are concerned. 2. ACCESSORIES DIM-30DE-1 DIM-30DE-2 Instruction Manual Inlet Hose...
ENGLISH NOTICE Remove shipping carton, tape(s) and packing. If packing material is left in the ice dispenser, it will not work properly. 1) After removing the packaging, make sure that the ice dispenser is in good condition. If in doubt, please do not use the ice dispenser and contact a professionally qualified person.
* Icemaking water must be potable water. Where scaling can be caused by water quality, installation of an external filter or softener is recommended. Contact your local water treatment professional or Hoshizaki service agent. * Water supply pressure should be minimum 0.07 MPa (0.7 bar) and maximum 0.78 MPa (8 bar). If the pressure exceeds 0.78 MPa (8 bar), use a proper pressure reducing valve.
ENGLISH * Be sure to use the new inlet hose-sets supplied with the appliance. Do not reuse any other inlet hose-set. * Ensure rubber tap washers are correctly positioned. Hand tighten the inlet hose sufficiently to provide a leak free joint. Water Supply Inlet Rc1/2 1/2-3/4 Nipple Inlet Hose Drain Outlet R3/4 Water Supply Tap Inlet Hose Outlet Hose [Connection to the drain] * Hand tighten grey flexible outlet hose (accessory) onto the R3/4 fitting on the rear of the icemaker as indicated, ensuring rubber washer is correctly positioned to obtain a leak free joint.
ENGLISH 1. START UP 1) Open the water tap. 2) Plug in the ice dispenser, and turn on the power switch to start operation. 3) After 30 - 60 minutes, press the push button and check for proper ice dispensing action. IMPORTANT When water supply is off or water pressure is too low, the ice dispenser will produce no ice or abnormal ice.
* Water is supplied to the unit and the water supply tap is open. * The air filter is clean. For further assistance or advice, contact your local Hoshizaki service agent. 3. DISPOSAL Comply with local regulations regarding disposal of this appliance and its refrigerant gas.
4. WARRANTY Hoshizaki warrants to the original owner/user that all Hoshizaki branded products shall be free of defects in material and/or workmanship for the duration of the “warranty period”. The warranty shall be effective for two years from the date of installation.