Interface Settings; Ethernet Driver - Canon IR 2420 Network Manual

Interface Settings

This section describes how to specify the interface settings from the control panel.
After physically connecting the machine to a network, you must specify the
communication mode (Half duplex/Full duplex) and Ethernet type (10 Base-T/100
Base-TX). You can also set the machine to automatically select these settings.
2
IMPORTANT
•
If you are configuring the interface settings for the first time, use the control panel of this
machine. After configuring the protocol settings, you can change them using the Remote
UI.
•
Settings that have been changed from the control panel become effective after the
machine is restarted.
NOTE
•
For instructions on how to make settings using the Remote UI, see Chapter 3,
"Customizing Settings," in the Remote UI Guide.
•
For instructions on how to enter characters, see Chapter 2, "Basic Operations," in the
Reference Guide.

Ethernet Driver

1
Press
The Additional Functions menu appears.
2
Additional Functions
2-2

Interface Settings

(Additional Functions).
Timer Settings
Adjustment/Cleaning
Report Settings
System Settings
Use [ ] or [ ] to select
<System Settings> ➞ press [OK].