Canon IR 2420 Network Manual page 22

Communication Mode
Full Duplex
Half Duplex
Auto Detect
Communication Mode
Ethernet Type
Ethernet Type
10 Base-T
100 Base-TX
7
Press (Reset) to return to the Standby display.
8
Restart the machine.
Turn OFF the machine, wait at least 10 seconds, and then turn it ON.
NOTE
For instructions on how to turn the machine ON and OFF, see Chapter 1, "Before You
Start Using This Machine," in the Reference Guide.
The Ethernet driver settings are complete.
❑
Use [ ] or [ ] to select <Full Duplex> or
<Half Duplex> ➞ press [OK].
Select <Full Duplex> to set the machine to
simultaneously send and receive data.
Select <Half Duplex> to set the machine to
alternately send and receive data.
❑
Use [ ] or [ ] to select <Ethernet Type>
➞ press [OK].
❑
Use [ ] or [ ] to select <10 Base-T> or
<100 Base-TX> ➞ press [OK].
Interface Settings
2
2-5