Center Module Search; Initialization - Panasonic WX-CT420 Operating Instructions Manual

Center Module search

This product searches for an accessible Center Module via
the Center Module in which the ID is already registered.
When an accessible Center Module is found, this product is
connected to that Center Module.
To use this function, it is necessary to register the ID in
multiple Center Modules in advance.
This function takes effect only when DIP switch No.4 is at
the OFF setting (WX-CC411, WX-CC412).
Hold down the [POWER] button for 2 seconds
or more to turn off the Belt Pack.
Press the [POWER] button for 1 second or
more while holding down the [R] and [+]
buttons to turn on the power.
The power indicator turns red and green alternately,
and the lane indicator blinks orange rapidly.
When an accessible Center Module is found,
the power indicator turns red and green
alternately, and the lane indicator blinks
orange slowly.
After 5 seconds, this product restarts automatically
and accesses the Center Module searched for.
Note
The ID of 1 unit of this product can be registered in
up to 30 Center Modules. The Center Module not
accessed for the longest time is overwritten when the
ID is registered in the 31
In the case of a Center Module in which the Belt
Pack's ID has not been registered, the voice message
"Failed" is heard from the speaker of the headset, and
the power indicator blinks red.
st Center Module.

Initialization

You can initialize this product to the factory settings.
Hold down the [POWER] button for 2 seconds
or more to turn off the Belt Pack.
Press the [POWER] button for 1 second or
more while holding down the [+] and [–]
buttons to turn on the power.
The power indicator lights up in green and the lane
indicator remains off.
When the [POWER] button is released,
initialization starts.
When initialization is finished, this product restarts
automatically.
Note
When initialization is finished, the ID is not registered,
the power indicator blinks red, and the lane indicator
turns orange.
19