Singer 650 Manual page 84

Every Few Months -
Clean
and ol the machine thoroughly, Use
-over (and cylider cover), The motor
SINGER oils and SINGER lubricants only,
requires no lubrication. Oiling of the mo-
which are availalhe for purchase at your
tor can result in its burning out.
SINGER SEWING CENTRE
Both are e-xtra
quality products,
especially prepared for
After oiling sew
line ec stsrfungon a scrap
sewing machines
of material to remove excess oil.
*
Clean And Oil Area Behind Face Plate
If the machine is to be stored away for an
Clean and apply a drop of SINGER oil to
indefinite period of time. a thorough brush-
each place shown
You will find this
cleaning to remove all traces of lint and
easier to do if you remove the top cover
fluff, followed by swabbing of all exposed
first
parts with a lint free brush saturated with
SINGER oil, is necessary to protect against
*
Also, apply a drop of oil to the hook
rust,
raceway.
" Clean And Oil Top Of Machine
All spats to be oiled are shown in the
illustration. Do not oil gears, but apply a
small amount
of SINGER lubricant to
them as indicated
To Remove And Replace Top Cover
*
Clean And Oil Bottom O Machine 8,f(.r
Move take-up lever to ifs lowest point
Re-
to illustration on page 841,
Move sarew A n lifts rigt hand Ben
Tilt machine back and remove screw B,
move screwl A and lift right hand end of
being careful not to lose washer, and
cover slightly and slide toward left and off
remove bottom cover from underside of
the mnachine
as
shown on illustration below.
machine. In case of class 670 machine, also
Replace cover by positioning it on top of
remove screw C and cylinder cover Clean
mahine with a slight overhang on the left
and oil each of the places indicated. Gears
sidt, slide cover to the right unfil it locks
are to be lubricated only. Replace bottom
r "iaute Replace and tighten screw A.
A
83