Installation - Audiovox Rampage ACC-56 Owner's Manual And Installation Manual

INSTALLATION

The ACC-56 changer is designed for horizontal (flat), vertical (upright) or 45-degree mounting. It must never be mounted upside-
down or on either one of it's sides as explained previously.
correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration
compensation will not be effective and vibration may cause the disc to skip.
CAUTION
After setting the built-in anti-vibration springs, place the supplied Seals (B) over the holes. These seals are used to keep dust, which could
cause a malfunction, out of the unit.
HORIZONTAL INSTALLATION
Set the 4 anti-vibration springs to
position "H".
position "H"
PROCEDURE FOR HORIZONTAL INSTALLATION
1
Attach bracket (L) and bracket (R) to each side of the unit,
using the hexagonal bolts with washer base (M5 x 8).
A n t i - v i b r a t i o n
springs position
NOTE: Use seals (A) to cover unused
mounting holes on sides of unit.
2
Determine the mounting location, and drill four mounting
holes.
Never mount the unit near the fuel tank.
3
Secure the unit in place, using four self-tapping screws
(M5 x 12).
Use RTV (silicone sealer) on screw threads or around
the holes to prevent moisture intrusion.
6
The position of the built-in anti-vibration springs (left and right side), must
VERTICAL INSTALLATION
Set the 4 anti-vibration springs to
position "V".
position "V"
Bracket (L)
Bracket (L)
Bracket (R)
45° ANGLE INSTALLATION
Set the 4 anti-vibration springs to
position "45°".
Hexagonal bolt
Bracket (R)
with washer base (M5 x 8)
Drill holes 4mm in diameter.
Self-tapping screw (M5 x 12)
position "45°"