Mounting The Remote Control - Audiovox Rampage ACC-56 Owner's Manual And Installation Manual

MOUNTING THE REMOTE
CONTROL
On the back of the remote control you will find an adhesive
backed "Velcro" pad. Select the desired mounting area on
your car dashboard that will allow ease of use and full
visibility of the LCD display. Peel off the protective paper on
the adhesive pad. Make certain the dash area is clean of all
wax, grease, etc., and press the remote control in place.
Allow a 1/2 hour for the adhesive to secure, then you will find
the Velcro pads will allow you to remove the remote control
for hand-held use if desired and replace it as often as
needed.
MOUNTING THE FM MODULATOR
There are two mounting tabs on the FM modulator. It can
be secured by two methods. Use two screws "C" and drill
two 3/32" holes or use electricians tape or twist ties (not
provided).
ADJUSTMENT OF FM MODULATOR
TUNING
To operate your ACC-56, your car radio must be first tuned
to the FM band at 89.1MHz. If you find interference on this
frequency, you can change the output frequency from the
FM module to 88.7 MHz., by moving the slide switch on the
FM modulator to the 88.7 MHz. position. You will then have
to tune your radio to 88.7 MHz instead of 89.1 MHz, when
using your CD changer.
12
CLEAN MOUNTING AREA
REMOTE
CONTROL
REMOVE PAPER LINER
AND PRESS IN PLACE
MOUNTING
SURFACE
FM MODULATOR
CAR DASHBOARD
DRILL TWO
3/32" DIA. HOLES
SLIDE
SWITCH
SCREW
"C"
(2 PCS.)
AUDIO LEVEL
ADJUST
FM MODULATOR