Handlebar Switches - Yamaha Tmax XP500 2016 Owner's Manual

Handlebar switches

Left
1
2
3
4
1. Pass switch "PASS"
2. Dimmer switch "
3. Turn signal switch "
4. Horn switch " "
Right
1. Engine stop switch "
2. Hazard switch " "
3. "ON/ " switch
Pass switch "PASS"
Press this switch to flash the headlight.
Dimmer switch "
Set this switch to "
beam and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
Instrument and control functions
EAU1234H
/ "
/ "
1
2
3
/ "
EAU12361
EAU12401
/ "
" for the high
EAU12461
/ "
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
"ON/ " switch
With the smart key turned on and within
range, press this switch to turn on the
power to the vehicle. Then with the sid-
estand up and while applying the front
or rear brake, push this switch to crank
the engine with the starter. See page
6-2 for starting instructions prior to
starting the engine.
The engine trouble warning light and
ABS warning light may come on when
the vehicle power is on and the "ON/ "
switch is pushed, but this does not indi-
cate a malfunction.
Hazard switch " "
With the vehicle power is on, or when
the smart key system is in parking
mode, use this switch to turn on the
hazard lights (simultaneous flashing of
all turn signal lights).
The hazard lights are used in case of
4-10
". When re-
EAU12501
"
EAU12661
/ "
" before starting
" to
EAU63631
EAU63571
EAU63580
1
2
3
4
5
6
7
8
9
10
11
12
13
14