Epson STYLUS PRO 5000 Setup Manual page 87

5. Insert the SIMM into the socket as shown below. Install from
the center-most slot first, and place the SIMM at about a 45°
angle, matching the notched end with the number 1 written
near the socket on the board.
6. Gently press the SIMM toward the back of the socket until it
snaps in to the clamps, straight up and down.
7. Slide the interface board unit back in to the compartment and
secure the interface board unit with the two screws.
8. Reconnect the interface cable and the power cord. If you are
using a Macintosh, the SIMM installation is finished.
9. If you are using Windows, open the printer driver and click
the Utility tab. See page 3-9 for information on opening the
printer driver.
4-12
Installing Options and Memory Modules