Protocols And Standards; Qinq Configuration Task List - HP 3100 Series Configuration Manual

when sent to the public network, carry the TPID value identical to the value of a particular vendor,
allowing interoperability with the switches of that vendor.
The TPID in an Ethernet frame has the same position as the protocol type field in a frame without a
VLAN tag. To avoid problems in packet forwarding and handling in the network, do not set the TPID
value to any of the reserved values.
Table 20 Reserved protocol type values
Protocol type
ARP
PUP
RARP
IP
IPv6
PPPoE
MPLS
IPX/SPX
IS-IS
LACP
802.1X
Cluster
Reserved

Protocols and standards

IEEE 802.1Q: IEEE standard for local and metropolitan area networks: Virtual Bridged Local Area
Networks

QinQ configuration task list

When you configure QinQ, follow these guidelines:
•
QinQ requires configurations only on the service provider network.
•
QinQ configurations made in Ethernet interface view take effect on the current interface only.
Those made in Layer 2 aggregate interface view take effect on the current aggregate interface
and all the member ports in the aggregation group. Those made in port group view take effect
on all member ports in the current port group.
Complete the follows tasks to configure QinQ:
Task
Enabling basic QinQ
Configuring selective QinQ (available only on the HPE 3100 v2 EI)
Configuring the TPID value in VLAN tags
Value
0x0806
0x0200
0x8035
0x0800
0x86DD
0x8863/0x8864
0x8847/0x8848
0x8137
0x8000
0x8809
0x888E
0x88A7
0xFFFD/0xFFFE/0xFFFF
152
Remarks
Required
Optional
Optional