Error Code Recall Mode - Lennox CBX32MV Installation Instructions Manual

Error Code / Recall Mode
To enter Error Code Mode,
push and hold button next
to single character LED
display until solid E symbol
appears, release button.
Control will display up to ten error codes stored
in memory. If E 0 0 0 is displayed, there are no
stored error codes.
E 0 0
To exit Error Code Recall Model, push and hold
button next to single character LED display until
solid three horizontal bars appears, then release
button.
NOTE Error Codes are not cleared from memory.
Yes
E
0
- -
-
AHC in Idle Mode
(No heating cooling or indoor
fan operation)
To clear error codes stored in
memory, continue to hold push button
while the solid three horizontal bars
are displayed. Release button when
solid is displayed.
Solid c starts blinking on
single character LED
The display will blink for up to ten seconds. During this time,
press the button and release to confirm deletion of the error code
history. As confirmation, AHC will display 0
second period expires or push button is not released, control will
automatically exit Error Code Mode and go into mode without
deleting error code history.
NOTE Once the error code history is deleted, it cannot be
recovered.
Page 35
No
Turn room thermostat to OFF
c
display.
0 0 0 . (If ten
0 0 0 0
- -
-
CBX32MV SERIES