Table of Contents
Advertisement
1/2" NPT Incoming
Black Iron Gas Line
A
7"
7"
Alternate Gas Supply
Through Sub-Floor
BRT 4036TEN, 4336TEN,
4536TEN, 4036TEP,
4336TEP, 4536TEP
A
8
/
" (21.9 cm)
5
8
Figure 17 - Routing Incoming Gas Line
Sediment
Trap (Not
Supplied)
3" Min.
(7.6 cm)
Figure 18 - Sediment Trap
CAUTION: Compounds used on threaded joints of
gas piping shall be resistant to the action of Liquefied
Petroleum (LP or propane) and should be applied lightly
to ensure excess sealant does not enter the gas line.
WARNING: All gas piping and connections must
be tested for leaks after the installation is completed.
After ensuring that gas valve is on, apply a commercial
leak detection solution to all connections and joints. If
bubbles appear, leaks can be detected and corrected.
Do not use an open flame for leak testing and do not
operate any appliance if a leak is detected.
Complete your gas installation by connecting incoming gas line
with flexible gas line. Secure tightly with wrench but DO NOT OVER-
TIGHTEN.
126737-01_E
INSTALLATION Continued
Flexible Gas Line
(1 Provided) Can
Be Extended Out
Either Side
B
BRT 4042TEN, 4342TEN,
4542TEN, 4042TEP,
4342TEP, 4542TEP
10
/
" (26.7 cm)
1
2
Incoming
1/2" Gas Line
Permitted by
Local Codes
SuperiorFireplaces.US.com
Flexible Gas Line
Gas Shutoff
Do NOT Kink
Valve
Note:
1) Wire Connections
1/2" NPT
Not Shown for Clarity
Incoming
2) * 1/8" NPT Plugged
Gas Line
Tapping
Figure 19 - Connecting Flexible Gas Line to Millivolt Valve
EMBER AND PAN MATERIAL PLACEMENT
1. Open bag(s) of vermiculite and fill entire burner pan until burner
tube is completely covered (see Figure 20).
2. Smooth pan material just even with edges of burner pan.
3. Remove ember material from bag and flatten small amounts into
quarter size pieces and lay on top of surface of pan material (see
Figure 21).
4. Place just enough to cover entire surface and leave about a 1/2"
gap under lower grate members to allow air to flow (see Figure
22).
Grate
Vermiculite
(Pan Material)
Figure 20 - Fill Entire Burner Pan with Vermiculite
Ember
Material
Grate
Figure 21 - Ember Material on Surface of Pan Material (Vermiculite)
0.5"
Figure 22 - Pan and Ember Material Clearances
Red Surface Indicates For
Propane/LP Use Only
ON
OFF
IN
OUT
Outlet
Pressure Tap
Inlet Pressure Tap
Burner Pan
Vermiculite (Pan Material)
Burner
Pan
Grate
Pan and Ember
Material
0.5"
Burner Pan
Pilot
Adj
11
Advertisement
Table of Contents
