Table of Contents
Advertisement
WALL SWITCH INSTALLATION
The installation of a wall switch allows you to activate the gas con-
trol valve and turn the fireplace on and off. The wall switch is to be
connected to the incoming 120 volt regular household wiring that
supplies electricity to the fireplace. Refer to wiring diagram in this
manual on page 18.
OPTIONAL REMOTE CONTROL INSTALLATION (Model WRC)
Note: If using optional wireless hand-held remote control, wall switch
must be in the ON position to be operational. The remote control then
becomes the switching mechanism for fireplace operation.
1. Remove front refractory access panel by lifting up and angling
out of firebox opening (see Figure 13).
2. The WRC model receiver does not require a battery. Receiver can
be installed by plugging the short extension cord into fireplace
receptacle. Plug receiver unit into extension cord. Plug ignition
module plug into receiver unit (see Figure 14).
3. Activate remote handset battery by removing insulating tab on
back of handset (see Figure 15). Battery is included pre-installed.
4. Once the battery is activated unit is ready to use.
5. Replace front refractory access panel.
Figure 13 - Removing Front Refractory Access Panel
Fireplace
Receptacle
Extension Cord
Figure 14 - Installing WRC Remote Receiver
10
INSTALLATION
GAS LINE HOOK-UP
gas supplier or a qualified service person.
gas supply is OFF.
A manual shutoff valve has been included in the appliance's gas sup-
ply system. You may consider installing an extra gas shutoff valve
outside appliance's enclosure (check with local codes) where it can
be accessed more conveniently with a key through a wall as shown
in Figure 16.
In conformance with local codes, route a 1/2" NPT gas line to appliance
through hole in left side of firebox or sub-floor as shown in Figure 17.
IHP recommends that a black iron gas line be routed from the gas
source, through a sediment trap (shown in Figure 18, page 11) and
into appliance. Once connected through appliance, a flexible gas line
may be used for ease of installation to gas control valve (see Figure
19, page 11).
Before connecting black iron gas line to inside of appliance a sediment
trap must be included outside appliance between gas line and gas
Remote
shutoff valve. It must extend down 3" beyond center of pipe. Prepare
Control
incoming black iron gas line with teflon tape or pipe joint compound
Receiver
(Check with local building codes).
Ignition
Module Plug
SuperiorFireplaces.US.com
Battery Cover
12 Volt Battery
Pull to Remove
Insulation Tab
Figure 15 - Installing Battery into Back of Handset
WARNING: Gas line hookup should be done by your
WARNING: Before you proceed, make sure your
CAUTION: Do not kink flexible gas line.
Key
Typical Exterior Wall Gas Shutoff Installation
Figure 16 - Manual Shutoff Valve Installation
Back of
Handset
Shutoff
Valve
Extension
126737-01_E
Advertisement
Table of Contents
