Bar Code Decoder Settings - Canon DR-5020 Instructions Manual

Chapter 2 Scanning a Document

Bar Code Decoder Settings

Perform the settings for scanning bar codes. These settings are enabled only
when the optional bar code decoder is installed.
These items are set in the Barcode Settings dialog box.
• When two or more bar code types are aligned horizontally, a recognition error may
occur. Select only one type of bar code in the bar code area setting.
MEMO
• Bar codes with addon codes cannot be detected at the same time as bar codes
without addon codes. When scanning originals containing both bar codes with addon
codes and bar codes without addon codes, be sure to set the area to detect in the
bar code area setting before you start scanning.
• When 400 dpi and duplex scanning is set, only bar codes within the A4 width can be
detected.
• When scanning originals containing two or more bar codes and you want to detect
only a specific type of bar code, set the area to detect in the bar code area setting.
When this area is set in the scan area setting, bar codes outside of the scan area are
also detected.
• When the bar code type is unknown, mark all bar code check boxes before scanning
the original so that all bar code types are automatically detected and the checksum is
not scanned.
• When a bar code is scanned, the file "Barcode.log" is automatically created in the
\Scanning Utility 5000 folder.
74