Cpc Signal Detection Outgoing Set - Panasonic KX-TA1232 Programming Manual

General Programming

[415] CPC Signal Detection Outgoing Set

Description
Enables or disables Calling Party Control (CPC) Signal Detection during the time between the
originated outside call and the established outside call. If this is enabled, the system
disconnects the line with the time set in program [405] CPC Signal Detection Incoming Set
when the CPC Signal is detected.
Selection
• Outside line (CO) number: 01 through 12,
• Enable (detection) / Disable (no detection)
Default
Disable
Programming
1.
Enter 415.
Display: 415 CPC OUTGOING
2.
Press NEXT.
Display: CO Line NO?
3.
Enter an outside line number.
To enter outside line number 01, you can also press NEXT.
Display example: CO01:Disable
4.
Keep pressing SELECT until the desired selection is displayed.
5.
Press STORE.
6.
To program another outside line, press NEXT or PREV, or SELECT and the desired
outside line number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• Some central offices (CO) may send CPC-like signals during the dialing sequence and an
attempt to make a call may be terminated. If your CO is such a type, select "Disable".
• Program [405] CPC Signal Detection Incoming Set is used to set CPC Signal Detection
Time.
• To assign all outside lines to one selection, press the
shows the contents programmed for outside line 01.
130
( =all outside lines)
key in step 3. In this case, the display
Programming Guide