Tew-740Apbo #2 Configuration - TRENDnet TEW-740APBO User Manual

TRENDnet User's Guide
15. Under WDS Setup, set the Service setting to Enable.
16. In the first field for item 1, check the Enable option and in the WDS Peer's MAC
Address fields, enter the MAC address of the 2
MAC1: AA:BB:CC:DD:EE:FF) noted earlier in this guide. Description field is optional.
Note: You will need to enter the wireless MAC address of your 2
below is only used as an example in this guide.
17. In the Security Type field above, it is recommended to select AES and assign a
passphrase. It is not required to create a point-to-point WDS link but strongly
recommended. This setting must match on both access points.
If you decide to apply encryption and assign a passphrase, select AES. Then scroll down
to the bottom under the AES section and enter Passphrase. The security type and key
must match on both access points. Then click Save to save the settings.
Note: It is strongly recommended to assign strong passphrase. We are only using the
encryption key 1234567890 as an example in this guide.
18. At the top of the page, click Reboot, then click the Reboot button on the GUI page
to commit all of the changes. This completes the configuration for TEW-740APBO #1.
© Copyright 2016 TRENDnet. All Rights Reserved.
nd
TEW-740ABPO (TEW-740APBO #2
nd
access point as the one

TEW-740APBO #2 Configuration

1. Repeat the same TEW-740APBO #1 configuration steps 1-9 for TEW-740ABPO #2.
2. On the TEW-740APBO #1 configuration step 10, use the IP configuration settings
below for TEW-740APBO #2.
Note: Please note that if your existing network IP subnet is different. You must assign IP
addresses available in your IP subnet to the access points accordingly.
TEW-740ABO #2 IP Configuration
IP Address: 192.168.10.51
IP Netmask: 255.255.255.0
IP Gateway: 192.168.10.1
3. Repeat the same TEW-740APBO #1 configuration steps 11-15 for TEW-740ABPO #2.
4. On the TEW-740APBO #1 configuration step 16, enter the MAC address of the 1
TEW-740ABPO (TEW-740APBO #1 MAC1: 00:11:22:33:44:55) noted earlier in this guide.
Description field is optional.
Note: You will need to enter the wireless MAC address of your 1
below is only used as an example in this guide.
5. Repeat the same TEW-740APBO #1 configuration steps 11-18 to complete the TEW-
740ABPO #2 configuration. This completes the configuration for TEW-740APBO #2
TEW-740APBO
st
st
access point as the one
11