Mounting Accessories ....................7 Table of Contents ..................2 Hardware Installation ................8 Use two P3.5 pan head screws to secure the TEW-735AP. The distance Product Overview ..................4 between mounting points is 2 and 3/4 inches (7cm)........8 Features ...........................
Features High power radio greatly expands wireless coverage Wireless Speed TRENDnet’s plenum rated business class N300 High Power PoE Access Proven 300 Mbps wireless n Point, model TEW-735AP, greatly increases wireless coverage as compared to standard access points. A variety of installation scenarios are Backward Compatible supported with Access Point, WDS AP, WDS Bridge, and Repeater modes.
Power LED Connectors Network LED DC Power 12V DC 1A Reset Push and hold for 2 seconds to reset TEW-735AP 10/100 PoE Network Port (Optional) Button Push and hold for more than 10 seconds to reset all settings to factory default.
TEW-735AP. The second label is including two sets of T-Bar clippers, two sets of screws, and a set of located on the bottom of the TEW-735AP. The default SSID, wireless key, spacers. administrator account, and administrator password can be found there.
Two additional bronze screw holes are provided for T-Bar mounting. Use Mount on Wall or Ceiling two P2.6 screws to secure the TEW-735AP to the T-Bar clip and then clip on the T-Bar. Use two P3.5 pan head screws to secure the TEW-735AP. The distance between mounting points is 2 and 3/4 inches (7cm).
TEW-735AP Operation Modes Universal Repeater When Repeater Mode is selected, the TEW-735AP functions as a wireless There are four operating modes provided by the TEW-735AP, Access repeater and is able to repeat the wireless signal of an access point. This Point, WDS Bridge, WDS, AP, and Universal Repeater.
System Management and Default Settings passphrase is printed on the device label as well. If you have a brand new TEW-735AP, or if you just reset the TEW-735AP to factory defaults by pressing and holding reset button for over 10...
Page 13
5. TEW-735AP will apply the password change and then reboot. Login show up. again with your new password. * If you connected to the TEW-735AP wirelessly, please make sure you are still connecting to the TEW-735AP after it reboot Enter the administrator login information (The default user name is...
The management subnet. You can leave it on default assists in the basic setup of the administrator password and management if you have only one TEW-735AP, but you have to change the IP address if IP address. Click the Wizard button in the System menu to access the you have more than one TEW-735AP.
Main status Operation Shows which operation mode is currently in use: Mode: Access Point, WDS AP, WDS Bridge, Universal The Main status page shows the TEW-735AP’s basic information. Repeater. System Shows the system time on the TEW-735AP. This Time: is important for schedule control and log accuracy.
TEW-735AP IPv6 Wireless Client List This page shows the TEW-735AP’s IPv6 link local address. You can This page shows all wireless clients connected to the TEW-735AP. manage the TEW-735AP using this IPv6 link local address if your computer is IPv6 enabled and is in the same broadcast domain. Put a pair of brackets around your IPv6 address to visit the management site.
The management subnet. You can leave it on default Setup Wizard if you have only one TEW-735AP, but you have to change the IP address if you have more than one TEW-735AP. The setup wizard is provided as part of the web configuration utility. It assists in the basic setup of the administrator password and management IP address.
Operation Mode Universal Repeater When Repeater Mode is selected, the TEW-735AP functions as a wireless You can choose the mode that best suits your network: Access Point, WDS repeater and is able to repeat the wireless signal of an access point. This AP, WDS Bridge and Universal Repeater.
TRENDnet User’s Guide TEW-735AP IP Settings The TEW-735AP has a static IP (192.168.10.100) set for management purposes. You can change this IP address to fit your network plan or manage multiple TEW-735AP. You can also set TEW-735AP to DHCP client to accept an IP dynamically.
DHCP Server Spanning Tree The TEW-735AP is equipped with a DHCP server to assign IPv4 addresses The TEW-735AP is designed for end point access as well as backbone dynamically. The assigning IP address range must be in the subnet that was used in IP Settings.
802.1X for your wireless security. Encryption Choosing Disable allows wireless clients to (Disabled): connect to the TEW-735AP without a password. ESSID Select the SSID which you want to set up the You can relay the authentication to remote Selection: RADIUS server by checking Enable 802.1X...
Displays the current status of the WPS Status: configuration. WPS is the simplest way to connect a wireless client to the TEW-735AP. Self Pin Code: Displays the PIN code for the TEW-735AP. You don’t have to select the encryption mode and fill in a long encryption SSID: Displays the SSID for WPS pairing.
Apply to save the changes. VLAN numbers. LAN VLAN MGMT is a special VLAN to manage TEW-735AP. Enabling management VLAN tagging will keep all services, for example DHCP Apply: Click this button to save and activate server and client, in this VLAN.
Specify the password for access to the Name: SNMP community with read/write access. System Specify the location of the TEW-735AP. SNMP Setting allows you to assign the contact details, location, Location: community name, and trap settings for SNMP. This is a networking...
Backup / Restore Settings Auto Reboot Settings This page allows you to save the current configurations. Click Save to save Click on Apply, the TEW-735AP will go through the reboot process your current configuration. automatically. To load configurations saved previously, click Browse… to find configuration file and then click Upload.
To find out if there is a firmware upgrade available for your and schedules. device, please check your TRENDnet model and version using the link. http://www.trendnet.com/downloads/ Time Setup: Choose a source of time to synchronize with.
Click Add to add a schedule rule entry. Select an entry TEW-735AP. Enter the IPv4 address you want to ping and click Start. The and click Edit or Delete Selected to change the entry. Click Delete All to result will be showed in the terminal down below.
Logout from the management page. The TEW-735AP allows only one or all of them on or off. Click the LED you want to change the action and management login at the same time. If you want to access the TEW-735AP then click Apply to save the changes.
Europe – EU Declaration of Conformity This product is herewith confirmed to comply with the Directives. Directives TRENDnet hereby declare that the product is in compliance with the essential requirements and other relevant provisions under our sole Low Voltage Directive 2006/95/EC responsibility.
EÜ põhinõuetele ja nimetatud direktiivist tulenevatele teistele Directiva1999/5/CE, 2006/95/CE e 2009/125/CE. asjakohastele sätetele. Slovensko TRENDnet izjavlja, da je ta TEW-735AP v skladu z bistvenimi English Hereby, TRENDnet, declares that this TEW-735AP is in [Slovenian] zahtevami in ostalimi relevantnimi določili compliance with the essential requirements and other relevant direktive1999/5/ES, 2006/95/ES in 2009/125/ES.
Go to http://www.trendnet.com/gpl or http://www.trendnet.com Download appropriately for safe shipment. Customers shipping from outside of the USA and section and look for the desired TRENDnet product to access to the GPL Code or Canada are responsible for return shipping fees. Customers shipping from LGPL Code.