Advertisement
If you have installed a second
weight
stack, go to
Figure 5.
If you have not purchased
the second
weight
stack,
please
camp]ere
the folJowing
steps
before
proceeding
to F~gure
5.
1.Remove
the blank shroud
from the rear of the
Factor 625.
2. Remove
the rotary cable from the unit and
also the assadated
shock cord.
3. Load the Leg Press Cable into the
D-Ring
in the position
the Rotary
Cable was
removed
from. Remove
the elastic shock cord
from the Rotary Cable and attach to the Leg
Press Cable as shown
(same
routing of elastic
cord as on Rotary Cable).
ELASTIC SHOCK CORD
LEG PRESS CABLE
(PB3236-01)
--
D:RING
1. Attach two (2) 4V2 w/l Clev;s Pulleys to the
t
'~
'--:~ ~
--~'-
Base Frame
and one {I) mare long cable
retaining
clip with existing hardware
after
removing
one (1) 41/2" w/2" Clevis Pulley
previously
installed.
(See Detail "A"). Route
~
cable
as shown.
The pulley
at the right
side (as ~k~.
LEG PRESS
C.ABLE
you face the back of the unit) has Leg Press
FRO,~ D-RING
cable from D-ring routed under and back up to
pulley shown
in Figure 2.
PULLEY-2 PL
LONG
R~AINING CUP-2 PL
. PULL~ -2 PL
SIDE VIEW
Advertisement
