Advertisement
STEP 2
A.
Screw the threaded end of the leg cable 4108) approximately
3/4" into
the end of the selector
shaft
(113) and tighten
]am nut securely
as shown.
B.
If upon completion of assembly, the head plate
411.7) does not sit on fop of the first
weight plate 467),
push the head plate clown, insert
the selector
pin (72) and perform several repetitions
at the station.
This will
relax the cable system and prevent the head plated from lifting
up.
C.
If after
completing step B. the head plate still
does not sH on top of the first
w~ight plate or if
there is excess slack in the cable system, adiust the threaded end of the cable accordingly
and
refighten
the iam nut,
Shroud Assembly Instructions
Use tthis
procedure $o assemble the shrouds of the ParoBody 950ST
Securely assemble th~ pec station
shroud (51) to"
the pec guid.e,,
rod support 44.:3) and the base (15) using
four
3/8 x 1 black button
head cap screws 459).
¯ (No~e: The pec station
shroud has no
3/I] X 1"
Advertisement
