Advertisement
Pec Dec Cable Assembly Instructions
Use this
procedure to assemble the pec dec cables of the ParaBody 950ST
Step C
Step F & H
Step G
I
1318 x ~-3/4."
0
Step D
__ E
Step
A.
B.
C,
1
In this
order,
route tthe threaded end of the let cable (107) through the top boom (20),
the
(15),
and the large hole in the pec guTde rod support
Screw the threaded end of the laf
cable (107) approx|mately
3/4" into
the end of the selector
shaft C 113) and fighfen,
jam nut securely as shown.
Securely assemble three 3_-,1/2"
pulleys (111) into the slots
of the top boom C20) using three 3/8
2-3/4"
bolts
C99), six 3/8'
Flange Spacers (74),
and three
3/8" nylock
nuts (83).
(Note:
Loop
cable around each pulley prior to inserting
it into the slot.)
Securely assemble two 3-1/2" pulleys
(111) into the slots
of the base (15) using two 3./'8
2-3/4"
bolts
(99),
four
3/8""
Flange Spacers (74),
and two 3/8" nylock nuts (B3).
(Note:
Loop
cable around each pulley prior to inserting
if into the slot.)
Secu'rely tighten
the bolts of the pec guide rod support (43) and fop boom (ZO) connect'ion
at
time. (Note: Center the pec guide rod support horizantally
and vertically
before tightening.
Apply two 1" x 1" gll~des (60). to the floating
pulley (30),
as shown.
Securely assemble one 4-1/Z" pulle~'
(.110)
to the flpafing
pulley
stop (32) using one 3/'8 x 2-.3/4"
bolt
(99~), two 3/8" flange spacers (.74),
and one 3/8" nylock
Securely assemble one 4-1/2"
pulley
(110).to
the floofin 9 pulley
(30) using one 3/B x 2" half
(100),
two 3/8" washers C78), and one 3/8 nylock
nut ~83).
Loop cable around pulley
and place the
floating
pulley (30) onto the floating
pulley stop (32).
18
Advertisement
