ParaBody ex 350 Assembly Instructions Manual page 11

358
61.
EX350 ASSEMBLY INSTRUCTIONS
Assembl~ one ( I ) SPRING PIN ASSEMBLY to the SPRING PIN ASSEMIIILY HOUSING located
the SEAT SUPPORT TUBE using one (l) KNOB, one (l) PLUNGER. one (1) SPRING, one
SPACER. and one (l) COTTER PIN. (SEE DETAIL
62.
63.
64.
65.
66.
67.
Insert one ( I ) I i 2 IN. SO. END CAP 12 GA into end ofthe SPRING PIN ASSEMBLY HOUSING
fl~e SEAT SUPPORT TUBE. (SEE DETAIL H)
Insert one ( I ) 2 IN. SQ. ENID CAP into front end of the ADJI]STABLE SEAT SUPPORT.
Assemble t~vo (2~ ROLLER PADS to the ADJUSTABLE SEAT SUPPORT, using one (1) ROLLER
PAD SHAFT. and two {2} STAR LOCK COLLARS. (SEEDETAIL J)
Attach the SEAT PAD to the ADJUSTABLE SEAT SUPPORT. using two (2) 3/8 X 3 IN. HEX HEAD
BOLTS and two t2~ 3 8 IN. LOCK WASHERS.
Place the .~DJUSTABLE SEAT SUPPORT ASSEblBLY into the SEAT SUPPORT TUBE l~catecl on
the BACK SEAT SUPPORT by disengaging the SPRING PIN ASSEMBLY.
Install one ( I ) THUMBSCREW into the SEAT SUPPORT TUBE. (SEE DETAIL H)
vtv WARNING v w~
MAKE SURE SNAP LINKS ARE FASTENED BEFORE DOING EXERCISES.
! !! WARNING ! !I
DO NOT OPERATE THIS MACHINE WITH LAT BAR OFF SAFETY HOOKS
EXCEPT DURING HIGH PULLEY EXERCISES. ALSO, LAT BAR !S NOT
TO BE USED FOR PULL-UPS. .
PLEASE NOTE:
IFUPON ASSEMBLY, THE HEAD PLATE DOES NOT SIT ON :FOP OF
THE FIRST PLATE, PLEASE PUSH HEAD PLATE DOWN, INSERT THE
WEIGHT PIN TO A DESIRED RESISTANCE AND DO A FEW REPS ON
ONE OF THE STATIONS. THIS WILL SEAT THE CABLE SYSTEM.AND
ALLEVIATE THE HEAD PLATE FROM SITTING UP.
PLEASE NOTE:
"~"
WE RECOMMEND CLEANING YOUR PRODUCT (PADS AND FI~kME) ON.
- REGULAR BASIS, USING WARM SOAPY WAT.ER. ALSO, TOUCH-UP
PAINT CAN BE PURCHASED FROM YOUR PARABODY DEALER, OR FROM
..
YOUR PARABODVCUSTO~tER SERVICE REP~SV.r~'rA¢IXq~
1-800-328-97i4
11