First, check the insulation between ①
terminals with pocket tester. Then apply 12 volts to
③
and ④
terminals, �
to ③
the continuity between ①
If there is no continuity, replace it with a new one.
FUEL MESH FILTER INSPECTION
AND CLEANING
● If the fuel mesh filter is clogged with sediment or
rust, fuel will not flow smoothly and loss in engine
power may result.
● Blow the fuel mesh filter with compressed air.
NOTE
If the fuel mesh filter is clogged with many
sediment or rust, replace the fuel filter cartridge
with a new one.
FUEL LEVEL GAUGE INSPECTION
● Measure resistance between the terminals when
float is at the position instead below.
Fuel float position Resistance between terminals
F
1/2
E
● If the resistance measured is out of the
specification, replace the gauge with a new one.
● Fuel level meter inspection.
and ②
and �
to ④ , and check
and ② .
Approx. 90 ~ 100 Ϊ
Approx. 38 Ϊ
Approx. 4 ~ 10 Ϊ
FUEL SYSTEM AND THROTTLE BODY 4-2-6
①
②
55
③
④