Section 8: Multiburner Configuration & Installation; Initial Assembly; Figure 23: Multiburner Damper Flange Installation; Figure 24: Typical Manifold Layout - Roberts Gorden Blackheat BH15UT Installation, Operation & Service Manual

SECTION 8: MULTIBURNER CONFIGURATION & INSTALLATION

8.1 Initial Assembly

See Page 9, Section 6 for linear heater assembly
instructions
See Page 20, Section 7 for U-tube heater assembly
instructions.

Figure 23: Multiburner Damper Flange Installation

Fan Tube
Weld Spot
Figure 24: Typical Manifold Layout (Linear and U-Tube Configuration)
Typical Fan
Arrangement
150 mm Hanger
Cross
(100 x 150 x 100 x 150)
NOTE: Be sure to
silicone seal all
manifold joints
Check layout drawings for location of manifold pipe
installation.
BH25UT
150 mm Manifold
Damper (Typical)
Cross
(100 x 150 x 100 x 150)
BH25ST
SECTION 8: M
ULTIBURNER
Damper Flange
Assembly
BH25UT
100 mm Manifold
Max
3000 mm
ID/ID Sleeve
100 mm Hanger
Reducer
(100 x 150)
BH25ST
C & I
ONFIGURATION NSTALLATION
Note:
Install in the
fully open position
BH25UT
Max
1000
mm
Tee
(100 x 100 x 100)
BH25ST
29