Table of Contents
Advertisement
STEP 15
~)
¯ Screw one of the threaded ends of the previously
removed HEAD PLATE CABLE approximately I"
into the end of the WEIGHT STACK SHAFT. See
FIGURE 15.
FIGURE 15
HEAD PLATE
CABLE
(67250)
STEP 16
¯ Route the thread end of HEAD PLATE CABLE up
and over the PULLEYS in the TOP BOOM above
the WEIGHT STACK. (Remove pulleys for case
of installation.)
¯ Screw the other threaded end of the HEAD PLATE
CABLE approximately
I" into the end of the shaft
on the D-RING. Scc FIGURE 16.
¯ SECURELY
tighten the pulleys connection from the previous step.
¯ Atljust out any slack in the two cable systems. (Refer to your 425103 iuslructious for the proper procedures.)
FIGURE 16
(67250)
!
12
Advertisement
Table of Contents
