Wpa/Wpa2-Personal (Psk) - D-Link DIR-803 User Manual

Section 4 - Security
It is recommended that you enable wireless security on your wireless router before your wireless network adapters. Please
establish wireless connectivity before enabling encryption.
1. Log into the web-based configuration by opening a web browser
and entering the IP address of the router (192.168.0.1). Click on
Setup and then click Wireless Settings on the left side.
2. Next to Security Mode, select WPA-Personal.
3. Next to WPA Mode, select Auto (WPA or WPA2), WPA2 Only, or
WPA Only. Use Auto if you have wireless clients using both WPA
and WPA2.
4. Next to Cypher Type, select TKIP and AES, TKIP, or AES.
5. Next to Group Key Update Interval, enter the amount of time
before the group key used for broadcast and multicast data is
changed (3600 is default).
6. Next to Pre-Shared Key, enter a key (passphrase). The key is
entered as a pass-phrase in ASCII format at both ends of the
wireless connection. The pass-phrase must be between 8-63 characters.
7. Click Save Settings to save your settings. If you are configuring the router with a wireless adapter, you will lose connectivity
until you enable WPA-PSK on your adapter and enter the same passphrase as you did on the router.
D-Link DIR-803 User Manual

WPA/WPA2-Personal (PSK)

43