Table of Contents
Advertisement
ALARM FUNCTIONS
When an alarm sounds, the camera performs output
functions depending on the setup.
Inputs:
• The alarm sensor connected to the ALARM IN termi-
nal on the camera
• The built-in VMD (Video Motion Detector) that
detects a motion in video by monitoring the speci-
fied area
Outputs:
• "Alarm" display appears in the upper center of the
main page.
• The picture files as an alarm sounds are stored in
the camera.
• An E-mail notifies the specified addresses of the
alarm activation with or without a picture file.
• The stored picture files are sent to the FTP server.
• The ALARM OUT terminal on the camera becomes
active.
• The notice of an alarm activation is sent to the server
specified in Panasonic Protocol Setup, using the
Panasonic's original protocol.
I When an Alarm Arises
• "Alarm" display appears in the upper right corner of
the main page. The alarm status display may delay
for a maximum of half a minute due to its refresh
cycle.
• The pictures as an alarm sounds are stored in the
memories of the camera.
The total storage number of the pictures depends
on three factors: pixel numbers, picture quality, and
the number of pre-alarm storage. The existing oldest
data will be replaced with new picture data when
the data volume exceeds over the memory capacity.
The tables below give guidelines of the available
picture numbers for the post-alarm storage.
When pre-alarm file is set to 20
Pixel
numbers
640 x 480
640 x 240
320 x 240
160 x 120
When pre-alarm file is set to none
Pixel
numbers
Super Fine
640 x 480
640 x 240
320 x 240
160 x 120
-48-
Picture quality
Fine
Normal
Super Fine
113
165
210
247
351
440
514
722
901
514
722
901
Picture quality
Fine
Normal
133
185
230
267
371
460
534
742
921
534
742
921
LOW
242
451
922
922
LOW
262
471
942
942
Advertisement
Table of Contents
