Table of Contents
Advertisement
I Network Setup (NETWORK
SETUP)
Set up network parameters when connecting the
10/100BASE jack with a network.
Notes:
• Access the setup menu from the PC to use the
DHCP or DNS server, because these settings are
not included in this window.
• Ask your system administrator or ISP (Internet
Service Provider) about available IP address, subnet
mask, and gateway, prior to setup.
• The assigned address should be a global type when
connecting via the Internet. Ask your ISP whether it
is.
** NETWORK SET UP **
IP ADDRESS
NETMASK
GATEWAY
HTTP PORT NO.
DHCP
RET
END
1. Move the cursor to NETWORK SETUP in the SETUP
menu window and press [SET]. The NETWORK
SETUP menu opens.
The factory default settings are as follows.
IP ADDRESS: 192.168.0.10
NETMASK: 255.255.255.0
GATE WAY: 192.168.0.1
HTTP Port Number: 80
DHCP: OFF
2. Move the cursor to the line you wish to edit, and
press [SET].
Parameters become editable.
3. Select a digit using [Left] or [Right].
4. Select a number in the digit using [Up] or [Down].
5. Repeat steps 2, 3 and 4 above appropriately until all
parameters are set.
6. Move the cursor to END and press [SET] to close
the setup menu and store new settings, or select
RET to go back to the SETUP menu.
Note: The port number assigned to the camera is
exclusive, and any other usage is not allowed.
192.168.0.10
255.255.255.0
192.168.0.
1
80
OFF
-35-
Advertisement
Table of Contents
