System - Panasonic AJ-YA120AG Operating Instructions Manual

Setup menus

SYSTEM

Item
Superimposed
No. No.
display
12 SYS H (HD) 0000
1320
2640
14 SYS SC (SD) 0000
0108
0216
15 VO SYS H (SD) 0000
0864
1728
16 SD SYS H (SD) 0000
0864
1728
18 SCH COAR (SD) 0000
0001
0002
0003
19 SCH FINE (SD) 0000
0032
0064
20 AV PHASE 0000
0100
0200
" " indicates the factory setting.
Setting
Superimposed
display
–1320 For adjusting the system phase of the HD SDI output signals (in 13.5 ns
: : increments).
0 –: The phase is advanced.
: : +: The phase is delayed.
1320 <Note>
The setting range is as follows:
O –1100 to 0 to 1100 when 59/60 is selected as the SYSTEM FREQ setting
O –1375 to 0 to 1375 when 23/24 is selected as the SYSTEM FREQ setting
–108 For adjusting the system phase of the VIDEO output and SD SDI output signals
: : (total variable range of over ±180 degrees).
0 –: The phase is advanced.
: : +: The phase is delayed.
108
–864 For adjusting the system phase of the VIDEO output signals (in 37 ns increments).
: : –: The phase is advanced.
0 +: The phase is delayed.
: : <Note>
864 The setting range is –858 to 0 to 858 when 59/60 is selected as the menu item
No.25 [SYSTEM FREQ] setting.
–864 For adjusting the system phase of the SD SDI output signals (in 37 ns increments).
: : –: The phase is advanced.
0 +: The phase is delayed.
: : <Note>
864 The setting range is –858 to 0 to 858 when 59/60 is selected as the menu item
No.25 [SYSTEM FREQ] setting.
0 For adjusting the SCH (sub-carrier to horizontal) phase of the VIDEO output
90 signals (4 positions in 90-degree increments).
180 The SC phase changes, and the H phase remains unchanged.
270
–32 For adjusting the SCH (sub-carrier to horizontal) phase of the VIDEO output
: : signals (variable range of over ±45 degrees).
0 The SC phase changes, and the H phase remains unchanged.
: : A range of ±180 degrees is covered by using this setting in combination with item
32 No.18 [SCH COAR(SD).
–100 For adjusting the phase of the AUDIO output signals in relation to the VIDEO
: : output signals (in 20.8 µs increments).
0 –: The phase of the audio output signals is advanced in relation to the video output
: : signals.
100 +: The phase of the audio output signals is delayed in relation to the video output
signals.
Description of settings
31