Panasonic AJ-D950 Operating Instructions Manual page 52

Setup menus
USER menu
<EDIT>
No.
3 0 0
3 0 1
3 0 2
3 0 3
3 0 4
3 0 5
3 0 6 EDIT
3 0 7
The underline on the setting item denotes the initial setting.
Item Setting
Superimposed No. Superimposed
display
display
0000
VAR –.43~ 1
RANGE 0001
–4~+4
0000
MANU
IN/OUT
0001 AUTO
DEL
0000
NEGA
FLASH
0001
0000
AUTO
STD/
0001
NON-STD
0002
N-STD
0000
AUTO
SERVO
0001
REF
0000 N-DEF
EDIT
0001
RPLCE1
0002
0003 CH1+2
0000
N-DEF
0001
RPLCE2
0002
CH1+2
0003
0000 N-DEF
EDIT
0001
RPLCE3
0002
0003 CH1+CH2
- 5 2 -
Description
This sets the VAR speed range.
0: The tape is played in slow motion at a speed ranging from
–0.43x to +1x normal speed.
1: The tape is played in the ±4.1x normal speed range.
This selects the operation to be performed when an edit point
has been set incorrectly (when the OUT point is before the IN
point).
0: Editing is not executed unless the illegal edit point is
cleared or set again properly.
1: The edit points already input are automatically cleared.
OFF
This selects whether to show a negative display when the IN
ON point is greater than the OUT point.
0: No negative display.
1: Negative display.
This selects STD or NON-STD in accordance with the compo-
STD site input signal.
0: Standard/non-standard signals are automatically identified
and processed.
1: Standard signals are processed. (Forced STD)
2: Non-standard signals are processed. (Forced NON-STD)
This selects the video signal processing.
EXT 0: Servo is synchronized with the input signal during recording
and editing, or with the REF signal during playback.
1: Servo is synchronized at all times with the REF signal.
This sets the channel assignments for the controller ' s analog
CH1
audio preset when editing the digital audio of the VTR using a
controller which does not have a digital audio edit preset
CH2
control function.
This selects the channel concerned when the VTR CH1 edit
preset is set in compliance with the ON or OFF presetting for
the analog audio signals designated by the controller.
0: Not set.
1: Compliance with analog CH1 edit preset.
2: Compliance with analog CH2 edit preset.
3: Compliance with either analog CH1 ot CH2 edit preset.
This selects the channel concerned when the VTR CH2 edit
CH1
preset is set in compliance with the ON or OFF presetting for
the analog audio signals designated by the controller.
CH2
0: Not set.
1: Compliance with analog CH1 edit preset.
2: Compliance with analog CH2 edit preset.
3: Compliance with either analog CH1 ot CH2 edit preset.
The same type of setting as No. 305. This selects the channel
concerned when the VTR CH3 edit preset is set in compliance
CH1
with the On or OFF presetting for the analog audio signals
CH2
designated by the controller.
0: Not set.
1: Compliance with analog CH1 edit preset.
2: Compliance with analog CH2 edit preset.
3: Compliance with either analog CH1 or CH2 edit preset.