Panasonic AJ-D950 Operating Instructions Manual page 49

USER menu
<OPERATION>
N o .
100
101
102
103
104 REF
105
106
107
The underline on the setting item denotes the initial setting.
Item Setting
Superimposed
Superimposed
N o .
display display
0000
SEARCH
ENA
0001
0000
SHTL MAX
0001
0002
0000
FF. REW
0001
MAX
0002
0000
AUDIO
MUTE 0001
0000
0001
ALARM
0000
AUTO EE
0001
SEL
BLACK
0002
NORMAL
EE MODE 0000
SEL 0001
0000
PLAY
DELAY
0015
- 4 9 -
DIAL
This selects the direct search dial operation.
KEY 0: For direct search dial operations.
1: Operation is not transferred to the search mode unless the
search button is pressed.
x8
This sets the maximum speed for shuttle operations.
x16
0: 8x normal speed
x32 1: 16x normal speed
2: 32x normal speed
x16
This sets the maximum speed for FF and REW operations.
x32
0: 16 (32)x normal speed
1: 32 (60)x normal speed
x50
2: 50 (100)x normal speed
<Note>
Values for the 411 (25M) mode are shown in parentheses ( ).
OFF
This sets the status until the audio signal is output when
ON operation switches from the stop or search modes to the play
mode.
0: The time until the audio is output is shortened.
1: The audio is output after the status stabilizes.
<Note>
When set to 0 (OFF), the sound in the initially output part is
incomplete. Therefore, this setting is not recommended for
broadcasts.
OFF
This selects whether to warn the operator when the
ON REF.VIDEO signal has not been connected.
0: Warning is not given.
1: Warning is given by the flashing STOP lamp.
S/F/R
This selects the VTR mode in which the EE status is
established when the TAPE/EE switch is set to EE.
STOP
0: EE status is established in the STOP, FF or REW mode.
However, EE status is always established in EJECT mode
regardless of the TAPE/EE switch setting.
1: EE status is established only in the stop mode. However,
EE status is always established in EJECT mode regardless
of the TAPE/EE switch setting.
2: EE status is established only in the stop mode. However,
depending on TAPE/EE switch setting EJECT mode is as
follows:
TAPE/EE switch EE:
TAPE/EE switch TAPE: BLACK status for video
This selects the EE mode output signals.
0: Signals are output with a delay equivalent to the length of
THRU
internal signal processing.
1: Signals are output directly, without internal processing, and
so are output with no delay.
<Note>
When editing mode is selected, SDTI is selected as the video
input signal, or INT SG is selected at either VIDEO or AUDIO,
he internal operations are forcibly set to NORMAL.
0
This set the play delay time in frame increments.
15
Description
EE status
MUTE status for audio