Table of Contents
Advertisement
Available languages
Available languages
Terminal connections
As shown below, firmly twist the end of the cord which
is to be connected to the terminal section.
Firmly twist or
solder here.
Solid wire
: 0.4 to 1.2 mm diameter
Twisted wire : 0.3 to 1.25 mm
(The diameter of the strands must be
0.18 mm or more.)
When connecting or disconnecting the
cord, press this part down using a
regular screwdriver.
O Failure to twist the end of the cord firmly can cause
short-circuiting.
Alarm recording connections
Alarm switch 1
When an alarm signal is input to
ALARM IN 1, alarm recording or
sensor recording is performed.
O When alarm recording has been set for MODE on
the menu screen shown on P4 ALARM/SENSOR
REC, alarm recording is started when the alarm
switch is set to ON.
O Alarm recording is released when the alarm reset
switch is set to ON.
Alarm switch 2
When an alarm signal is input to
ALARM IN 2, alarm recording or
sensor recording is performed.
Alarm reset
switch
+
4V to 5V
–
1 2
GND
IN OUT
IN
RESET
OUT
EXT
TIMER
ALARM
REC IN
GND TIME ADJ IN
35
External alarm lamp
External alarm buzzer
External interface
WARNING
/REC OUT
TAPE END OUT
Advertisement
Chapters
Table of Contents
