Panasonic AG-DTL1 Operating Instructions Manual page 100

RS-232C
$ Query control commands
Data transmitted by PC
[STX] QUI [ETX]
[STX] QVC [ETX]
[STX] QVM [ETX]
[STX] QWB [ETX]
[STX] QXT [ETX]
Data returned from unit in response
[STX] LUISdata [ETX]
Parameter
data = U U U U U U U U U
7 6 5 4 7 3 2 1 0
Sets the user ID to be written using an
ASCII code.
Binary 4BITa8
7
ASCII code: 0—9, A—F
[STX] VVCm:data [ETX]
Parameter
m = A: Execution of detection
processing by VCC command
underway
S: Detection processing by VCC
command completed or
detection stopped
data = c c c c
13-16 9-12 5-8 1-4
c = 1—F:
13-16
Connection information for camera
No.13—16
c = 1—F:
9-12
Connection information for camera
No.9—12
c = 1—F:
5-8
Connection information for camera
No.5—8
c = 1—F:
1-4
Connection information for camera
No.1—4
<Note>
For details on C¢, refer to the Camera
connection information table.
[STX] VMDm [ETX]
Parameter
m = A: AUTO
Color is switched automatically
in accordance with the input
signals.
B: B/W
Monochrome
[STX] LWBm [ETX]
Parameter
m = N: Buzzer ON
F: Buzzer OFF
[STX] LXTm [ETX]
Parameter
m = N: Signals are acknowledged.
F: Signals are not acknowledged.
100
Description of command
Queries the setting of the user ID to be recorded.
Queries the results of detecting whether the video input
signals are present.
<Note>
When the POWER switch is at OFF, the signals are not
detected, and an error results.
Initiate the detection processing using the VVC command
before executing the QVC command.
Correct results cannot be obtained unless processing has
been completed using the VVC command.
Queries the color setting for the video output signals.
Queries the setting for whether the buzzer is to sound when
a problem occurs in the unit and the power is automatically
turned off.
Queries the setting for whether the signals from the external
timer connected to the rear panel terminal section are to be
acknowledged in the external timer recording mode.