Napoleon high country nz3000h Installation And Operating Instructions Manual page 29

29
SETTING DEPTH OF PROBE
B
A
EN
Set the depth to 3.5" and secure with
Slide collet onto probe.
set screw.
WIRE ROUTING FOR WALL MOUNT
TAKE CARE WHEN ROUTING THE PROBE WIRE NOT TO DAMAGE OR CUT IT.
WHEN WALL MOUNTING, IT IS IMPORTANT TO KEEP THE MONITOR AT LEAST 8" AWAY FROM THE
SIDE OF THE UNIT. NEVER INSTALL DIRECTLY ABOVE THE APPLIANCE.
If wall mounting, remove the knock-out and cut out corresponding insulation for routing the probe wire.
A
B
Cut away or poke through the insulation
Remove the knockout tab.
to provide a route for the probe.
W415-1517 / A / 09.02.16