Removing The Expansion Card Riser - Dell PowerEdge R430 Owner's Manual

Card priority Card type
2 Infiniband Single Port/Dual Port
(Mellanox)
3 40 Gb NICs (Low profile)
40 Gb NICs (Full height)
4 10 Gb NICs (Low profile)
10 Gb NICs (Full height)
5 FC8 HBA (Low profile)
FC8 HBA (Full height)
6 1 Gb NICs (Low profile)
1 Gb NICs (Full height)
7 12 GB-SAS-HBA (Low profile)
12 GB-SAS-HBA (Full height)
8 Non-RAID HBA330

Removing the expansion card riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
Holding the touch points, lift the expansion card riser from the riser connector on the system board.
124
Slot priority
2
2
1
2
1
2
1
2
1
2
1
Integrated Slot
Maximum allowed
1
1
1
1
1
1
1
1
1
1
1
1