Yamaha xvs650 Supplementary Service Manual page 35

FRONT BRAKE
CAUTION:
Disc brake components rarely require dis-
assembly. DO NOT:
S disassemble components unless abso-
lutely necessary;
S use solvents on internal brake compo-
nents;
S use spent brake fluid for cleaning; (use
only clean brake fluid)
S allow brake fluid to come in contact with
the eyes, as this may cause eye injury;
S splash brake fluid onto painted surfaces or
plastic parts, as this may cause damage;
S disconnect any hydraulic connection, as
this would require the entire brake system
to be disassembled, drained, cleaned,
properly filled and bled after reassembly.
BRAKE PAD REPLACEMENT
NOTE:
It is not necessary to disassemble the brake cal-
iper and brake hose to replace the brake pads.
1. Remove:
S Retaining bolt 1
2. Remove:
S Brake pads 1
NOTE:
S Install new brake pad springs when the brake
pads have to be replaced.
S Replace the brake pads as a set if either is
found to be worn to the wear limit.
3. Install:
S Brake pads
S Brake pads spring
***************************************
Installation steps:
S Connect a suitable hose 1 tightely to the
brake caliper bleed screw 2 . Put the other
end of this hose into an open container.
–27–
CHAS