Installation; Mounting In The Rack - Panasonic WJ-MP204C Operating Instructions Manual

INSTALLATION

Warning!
Only qualified service personnel or system installers
should make all rack mountings, connections or internal
settings. If adjustments are required, please refer to the
Service Manual available for this product.

Mounting in the Rack

Remove the four rubber feet by removing the four screws
from the bottom of the WJ-MP204C.
Mounting One WJ-MP204C with the
WV-Q204/1
1. Fix the mounting brackets (large and small) on both
sides of the WJ-MP204C with the eight supplied screws
(M3x8) to the WV-Q204/1.
Mounting two WJ-MP204Cs with the
WV-Q204/2
1. Place the joint metals on the WJ-MP204Cs as shown
below and fix them with the supplied screws (M3x6) to
the WV-Q204/2.
Note: Remove the two screws from the rear of each
WJ-MP204Cs.
Rack mounting
bracket (small)
2. Install the WJ-MP204Cs with the rack
mounting brackets on the rack using
four screws (not supplied).
Cautions:
• Do not block the ventilation opening or slots in the
cover to prevent the appliance from overheating.
Always keep the temperature in the rack within +45°C
(113°F).
• Secure the rear of the appliance to the rack by using
additional mounting brackets (procured locally), if the
rack is subject to vibration.
• Do not use tapping screws for installing the WJ-
MP204C on the rack with the rack mounting brackets.
9
Rubber feet
Rack mounting
bracket (small)
Joint metal
Rack mounting
bracket (small)
Mount screw
Flat head (M3x6)
Rack mounting screws
Rack mounting
bracket (large)
Remove 2 screws from
the rear beforehand.
Mount screw
Binding head
(M3x8)