Alarm/Remote Terminal Setting - Panasonic WJ-MP204C Operating Instructions Manual

8 PS Data
•
Address Assignment
Unit address
given to WJ-MP204C
8 Camera Communication Protocol
As shown in the table, the UNIT switch determines the camera unit numbers.
Address Assignment
Connector
CAMERA IN/OUT

Alarm/Remote Terminal Setting

The rear of the unit is provided with an 11-pin terminal, ALARM/REMOTE.
A L A R M / R E M OT E
9 8 7 6 5 4 3 2 1
G N D G N D
Pins from #1 to #5 perform as follows.
Pin #1 supplies an active output for the duration specified by the ALARM OUTPUT in the setup.
The output type is a low-active open collector with a capacity of 16 V DC, 100 mA maximum.
Pin #2 accepts an alarm reset pulse (input) that makes the unit reset the alarm mode.
A no-voltage make-contact is accepted.
Pin #3 supplies an alarm reset pulse (output) when the unit resets the alarm mode.
The output type is 0 V (active)/5 V for the default setting, or a low-active open collector with controllable capacity of 16 V
DC, 100 mA maximum after changing an internal switch (SW 704).
Pin #4 accepts a spot switching pulse (input) from other units in a multi-unit connection.
A no-voltage make-contact is accepted.
Pin #5 supplies a spot switching pulse (output) to other units when the unit selects a new camera channel in a multi-unit
connection.
The output type is a low-active open collector with a capacity of 16 V DC, 100 mA maximum.
Pins #6 to #9 are used in many ways depending on the menu settings and the internal connector settings. If internal adjust-
ments are required, please refer to the Service Manual available for this unit.
16
0 1
Set the
number in
1
Setup
menu
0 1
1
1
Set the
2 2
number in
Setup
3 3
menu
4 4
UNIT Switch Position
2 3 4
2 3 4
UNIT Switch Position
2 3 4
5 9 13
6 10 14
7 11 15
8 12 16
5 6 7
5 6 7
5 6 7
17 21 25
18 22 26
19 23 27
20 24 28
8 9
Do not
8 use,
reserved
8 9
29
Do not
30
use,
31
reserved
32