Date/Time Commands; Console Port Speed - ZyXEL Communications nwa series Reference Manual

Chapter 14 System

14.3.1 Date/Time Commands

The following table describes the commands available for date and time setup. You must use the
configure terminal
commands.
Table 44 Command Summary: Date/Time
COMMAND
clock date <yyyy-mm-dd> time <hh:mm:ss>
[no] clock daylight-saving
[no] clock saving-interval begin
{apr|aug|dec|feb|jan|jul|jun|mar|may|nov|oct|sep}
{1|2|3|4|last} {fri|mon|sat|sun|thu|tue|wed} hh:mm
end {apr|aug|dec|feb|jan|jul|jun|mar|may|nov|oct|sep}
{1|2|3|4|last} {fri|mon|sat|sun|thu|tue|wed} hh:mm
offset
clock time hh:mm:ss
[no] clock time-zone {-|+hh}
[no] ntp
[no] ntp server {fqdn|w.x.y.z}
ntp sync
show clock date
show clock status
show clock time
show ntp server

14.4 Console Port Speed

This section shows you how to set the console port speed when you connect to the NWA/WAC via
the console port using a terminal emulation program. The following table describes the console port
commands. You must use the
before you can use these commands.
Table 45 Command Summary: Console Port Speed
COMMAND
[no] console baud baud_rate
show console
78
command to enter the configuration mode before you can use these
DESCRIPTION
Sets the new date in year, month and day format
manually and the new time in hour, minute and second
format.
Enables daylight saving. The
daylight saving.
Configures the day and time when Daylight Saving Time
starts and ends. The
time when Daylight Saving Time starts and ends.
offset: a number from 1 to 5.5 (by 0.5 increments)
Sets the new time in hour, minute and second format.
Sets your time zone. The
zone settings.
Saves your date and time and time zone settings and
updates the data and time every 24 hours. The
command stops updating the data and time every 24
hours.
Sets the IP address or URL of your NTP time server. The
no
Gets the time and date from a NTP time server.
Displays the current date of your NWA/WAC.
Displays your time zone and daylight saving settings.
Displays the current time of your NWA/WAC.
Displays time server settings.
configure terminal
DESCRIPTION
Sets the speed of the console port. The
the console port speed to the default (
baud_rate: 9600, 19200, 38400, 57600 or 115200.
Displays console port speed.
no
command removes the day and
no
command removes time
no
command removes time server information.
command to enter the configuration mode
NWA/WAC Series CLI Reference Guide
command disables
no
command resets
no
).
115200