Vcr Output Channel Setting - Sanyo VWM-700 Instruction Manual

CABL ANTENNA(CATV) CONNECTIONS (Cont'd)
75 ohm Cable System
TV set
2-way Splitter
'-r--T---.--r'
(Not supplied)
This cable hookup allows you
either to view and record the
same channel (scrambled or
non-scrambled signal), or to
view one channel (non-scram-
bled signal) while recording
another channel (scrambled or
non-scrambled signal).
CABLE CONVERTER
c::::J
VCR'S Back Panel
75 ohm Coaxial
Cable (supplied)
Note to CATV system installer (USA only): This reminder is provided to call the CATV
system installer's attention to Section 820-40 of the NEC which provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of cable entry as practical.
VCR's BACK PANEL
~
fYY"
i
IN OUT
~ ®-®L
f~ ~3
Y.~~
ANT .IN
VHF/UHF
/CATV
·0
VCR OUTPUT CHANNEL SWITCH
During playback of a video tape, and when press TV NCR to set
the VCR mode, the VCR OUTPUT converter changes the video
and audio signals to the same type of signals that are used for
TV broadcasts. Set the VCR OUTPUT channel switch (marked
CH3, CH4 and located on the rear panel) to channel 3 or 4.
Select the channel that is not used for TV broadcasts in your
area.
This is your VCR OUTPUT channel. To play a tape, or to watch
TV using the VCR's built-in tuner, always set your TV's channel
selector to the same channel (3 or 4).
9