Table of Contents
Advertisement
2
VCR PRESETTING
PREPARATION
After all the connections
are completed,
please follow steps
~~
to -
before using the VCR.
PRESET
WI
1!
CH (+, -)
OK
-
VCR tuning (Auto tuning)
If the VCR has been connected to the TV
using the "AV connection",
simply set
your TV to the "AV" mode.
Go to m.
1
2
,,
., --.,
,.,.
,,,
.,
i urn on
me v~~ using me CVI rx-mon.
The AUTO SETUP screen is displayed.
(TV screen)
In case of an RF connection
Setting the TV to the video channel
AUTO SETUP
[OK 1 *ENTER
[ MENU 1+TV
1
2
3
4
M
AUTO SETUP
-----------
-----------
-----,
:[OK 1 *ENTER
, [MENU I
TV
. . . . . . . . . . . . . . . . . . . . . . . . . . -'
Turn off the VCR using the
(!)/1
button
Turn on your TV and set your TV to
"VCR" or the position designated for VCR
use (always a position where no TV
programme
is received).
Press the
OK
button.
Auto tuning will start.
Auto tuning
This VCR has a built-in tuner capable of
tuning up to 88 TV stations.
The TV stations available in your area will be
automatically
preset in order starting from
programme
position number "01".
Because of this you may have to sort the TV
The buttons that can be used
with each menu are displayed
at the bottom of the screen.
The settings are entered with
the remote control.
If you want to recall the AUTO
El
VCR
00
SETUPscreen, simply press
both
CHANNEL (+ and-)
buttonson the
VCR for 3
Press the
PRESET
button on the remote
control for more than 3 seconds.
stations into the correct order. Please refer to
The VCR display shows "28 RF.
"Sorting the
TV stations".
(VCR
display)
When
the Auto
tuning
is finished,
the TV
seconds or more.
station preset to the lowest programme
position number will be tuned on your TV
screen.
Notes:
Set the UHF channel using the
CH+
(for
During the auto tuning operations, please do not
press any of the buttons or controls on the VCR
Australia) or CH– (for New-Zealand)
button on the VCR remote control, so that
or remote control.
Auto tuning is not possible if the VCR is set to
AV input mode.
The skip function will be automatically
set for all
position numbers where no TV station has been
preset,
the test pattern (2 vertical bars) appears.
(for Australia)
RFconverteroutput
(Video channel)
mRlllm
(for New Zealand)
m
mllmm
'o
Area
I
Factory
setting
Range
28-69
22-69
Australia
~
28
New Zealandl
28
When the VCR channel position on the
TV (UHF 22 (28) to 69) matches the
RF channel, the test pattern appears.
The output channel of the VCR (video
channel) is preset at the factory to be
received by your TV receiver on UHF
channel 28.
Adjust the tuning on the TV, if necessary,
so that the test pattern is clear.
5
When completed, press the PRESET button.
The VCR is turned off.
This completes the video channel setting.
Advertisement
Table of Contents
