Transport,
e.g. when moving
Preparing and inserting the
transport bolts
Before transporting the washing machine
- Turn off the tap,
- reduce the water pressure in the water inlet hose
(see Page 44),
- drain any residual washing solution (refer to
Page 42),
- disconnect the washing machine from the power
supply,
- dismantle the supply and drainage hoses.
- install the lower 2 transport bolts.
Having transported the appliance and ensured
proper installation and connection, allow the Drain
programme to run through before starting the first
wash programme.
q Remove the covers.
q Preparing the transport bolts:
Pull the bolt out of the sleeve until the end of the
bolt is flush with the end of the sleeve.
q Insert and tighten the transport bolts.
The lug on the washer must be located in the
groove in the rear panel of the housing.
65