Transport, Such As When Moving Out - Bosch Nexxt 100 Series WFMC1001UC Operating, Care And Installation Instructions Manual

q A center-located bubble
indicates the unit is leveled.
Otherwise, repeat the leveling
procedure until the unit is
leveled. Tip: if the bubble is
closer to one end, it indicates
the high side of the unit. To
level the unit, either lower the
higher side or raise the lower
side.
q After leveling the unit from side
to side, then turn the level so
that it lays on the worktop from
front to back to also check the
level in that direction.
5. Fine tune the leveling by placing a
small load of laundry in the
machine, starting it in spin cycle
and then leveling the washer
again.
i If the test spin cycle is manually
stopped before its completion,
then the door may remain locked
for 10 seconds.
12
Transport, such as when
moving out
Before transporting the washing
machine:
- Turn off the water.
- Disconnect the washing machine
from the power outlet.
- Dismantle the supply and drainage
hoses.
- Install the transport bolts.
i
Having transported the appliance
and ensured proper installation
and connection, allow the Drain
program to run through before
starting the first wash program.
Preparing and inserting the
transport bolts
Remove the covers.
q
Prepare the transport bolts:
q
Loosen the screw in the sleeve
until the end of the screw is level
with the end of the sleeve.
Insert and tighten all transport
q
bolts. Make sure that the tab on
the transportation bolt is inserted
in the slot on the washing machine
back panel.