Konica Minolta bizhub Pro 951 Additional Information page 38

2
14
Measure the misalignment between the
of the output chart.
% The figure below shows an example of measuring [1]. The scale interval is 0.5 mm.
% The black
% Measure the misalignments in the X direction and Y direction.
% You can enter the value in 0.1 mm increments.
% Be sure to make note of the measured values.
% For example, when
mm in negative y direction as shown in the figure below, press [2], [0], and then [+ <-> -] for x and
[1] then [5] for y in order to shift the gray line on the back side of [1] 2.0 mm in negative x direction
and 1.5 mm in positive y direction.
15
Press [X] or [Y] of each point, and then enter the measured value using the touch panel keypad or [,]
and [+].
% If the misalignment of the print position is in negative direction, enter a positive value. If it is in pos-
itive direction, enter a negative value.
% Use [+<->-] to specify the value to be positive or negative.
% Press [Clear] to reset the value.
2-20
in the figure represents the front side, and the gray
of [1] on the back side is misaligned 2.0 mm in positive x direction and 1.5
The Workflow of Both Sides Adjust
marks [1] to [4] on the [back] side and
bizhub PRESS 1250/1250P/1052, bizhub PRO 951
on the [front] side
represents the back side.
2.2