Radio And Ac Mains Lead Connections; Preparing The Remote Control - Panasonic SC-HT855 Operating Instructions Manual

HT855En.book Page 10 Tuesday, March 7, 2006 2:33 PM
5

Radio and AC mains lead connections

STEP
AM loop antenna
≥ Connect the AC mains lead after all other connections are complete.
≥ Using an outdoor antenna (optional) (➜ page 29).
AM loop antenna
Stand the antenna up on its base.
Place the antenna where reception is best.
Keep loose antenna cable away from other wires
and cables.
AC mains lead
To household mains socket
Conserving power
The main unit consumes a small amount of power, even when it is turned off (approx. 0.5 W). To save power when the unit is not to be used for a
long time, unplug it from the household mains socket.
You will need to reset some memory items after plugging in the unit.
[Note]
The included AC mains lead is for use with this unit only. Do not use it with other equipment. Also, do not use cords for other equipment with this unit.
6

Preparing the remote control

STEP
Remote control
2
Insert so the poles (i and j) match those in the remote control.
3
R6/LR6, AA
10
FM indoor antenna
Click!
While pushing, insert the wire fully.
Red
Batteries
1
≥ Do not use rechargeable type
batteries.
FM indoor antenna
Affix this end of the antenna where
reception is best.
Adhesive tape
White
Loosen the terminal
screw with a Phillips-
head screwdriver.
Black
Do not:
≥ mix old and new batteries.
≥ use different types at the same time.
≥ heat or expose to flame.
≥ take apart or short circuit.
≥ attempt to recharge alkaline or manganese batteries.
≥ use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (➜ page 12), avoiding
obstacles, at a maximum range of 7 m directly in front of the unit.
AC mains lead
Main unit
Re-tighten the
terminal screw.