Table of Contents
Advertisement
****************************************************************
*
Restore Backup Configuration
* This procedure only applies to storage controllers that
* are configured as an HA pair.
*
* Choose Yes to restore the "varfs" backup configuration
* from the TFTP server. Refer to the Boot Device Replacement *
* guide for more details.
* Choose No to skip the backup and recovery and return to the *
* boot menu.
****************************************************************
Do you want to restore the backup configuration
now? {y|n} y
Enter the IP address of the server: target_node.management_IP.address
Checking network link... success.
Checking route to host "target_node.management_IP.address"... success.
Attempting to reach "target_node.management_IP.address"... success.
Checking CompactFlash card file system... success.
Mounting CompactFlash card to /tmp/mnt... success.
Checking CompactFlash card mount point... success.
Restoring backup configuration... Received 82481 bytes in 0.1 seconds
Backup Configuration from $BACKUP_DATE successfully restored
Installing the CompactFlash card and transferring system files nondisruptively
using netboot in systems running Data ONTAP 8.1.1 and later:
You can transfer the system files and restore configuration information to your HA
pair nondisruptively by using netboot and the partner node.
Before you begin
v You must have the blank replacement CompactFlash card that you received from
your provider.
v You must have a network interface to the HA pair partner node.
v You must have a separate IP address to use to netboot the target node.
About this task
The following procedure is written with the assumption that the target node has
been taken over by the partner node and that the target node has booted to the
boot environment prompt after the takeover has been completed.
Attention: You can only use this nondisruptive procedure in an HA pair that is
running Data ONTAP 8.1.1 and later.
Procedure
1. Download and extract the file used for performing the netboot of your system:
a. Download the appropriate netboot.tgz file for your platform from the
IBM N series support website to a web-accessible directory.
b. Change to the web-accessible directory.
c.
Extract the contents of the netboot.tgz file to the target directory by
entering the following command:
tar -zxvf netboot.tgz
Your directory listing should contain the following directory:
netboot/
*
*
*
*
*
*
*
Chapter 5. Replacing N7000 series system devices
49
Advertisement
Table of Contents
