IBM N7800 Hardware And Service Manual page 71

To copy the backup system configuration file using...
A CIFS client
11. Close the .zip program.
12. Right-click the drive letter that is mapped to the CompactFlash card, select
Installing the CompactFlash card into the 7-Mode controller:
After the system files are transferred to the replacement CompactFlash card, you
must install it into the controller.
Procedure
1. If you are not already grounded, properly ground yourself.
2. Remove the bezel, if necessary, and locate the CompactFlash card slot in the
3. Align the CompactFlash card with the CompactFlash card socket or connector,
4. Check the CompactFlash card to make sure that it is seated squarely and
5. Replace the bezel.
6. Reinstall the cable management tray and recable the system, as needed. When
7. Push the motherboard tray all the way into the system, firmly push the cam
8. Reconnect the power cables to the power supplies and to the power sources,
Eject to remove the CompactFlash card from the PC or laptop, and then
remove the CompactFlash card from the CompactFlash card reader/writer.
LCD module.
and then firmly push the CompactFlash card into the socket or connector. The
CompactFlash card socket is keyed. If you feel resistance while pushing the
card into the socket, check the orientation of the card.
completely in the socket or connector. If necessary, remove the CompactFlash
card and reseat it into the socket.
recabling, remember to reinstall the media converters (SFPs) if you are using
fiber cables.
handle to finish seating it, push the cam handle to the closed position, and then
tighten the thumbscrews.
and then turn on the power.
Complete the following substeps...
1. Open Windows Explorer and enter the path to the
partner controller by entering the following command
in the navigation pane:
\\partner_node_name\c$
2. Open the /etc folder.
3. Copy the varfs.tgz file and paste it into target
directory.
4. Go to the PC and copy the varfs.tgz file to the
freebsd/ directory.
The directory structure should appear as follows:
x86_64/
freebsd/
image1/
image2/
varfs.tgz
diag/
firmware/
common/
firmware/
5. Go to the next step.
Chapter 5. Replacing N7000 series system devices
45